PX-5S
Firmware Version 1.10 User's Manual
Changed in firmware version 1.10
The differences from firmware version 1.00 are as follows.
* Improving the Key Follow function of Hex Layer
* Adding a portamento function to the Melody tones and the Hex Layer tones.
* Adding a volume control to the Audio Recorder
* Adding a volume control to the Damper Noise.
* Adding 'Toggle Mode' to the Pedal Function.
* Adding MIDI Rx message filters.
* Expanding the frequency range of the Master Equalizer.
* Expanding the frequency range of the DSP Equalizer.
* Adding a Fine tune to the DSP Pitch Shifter.
* Adding a Bypass to the System Effects and the Master Effects.
* Adding destination parameters to the controllers (Knobs, Sliders, Modulation and Pedals).
* Adding a calibration function of the position of the Knobs.
* Adding a sample waves to the Hex Layer.
Compatibility of the data
The compatibility of user data between firmware 1.00 and 1.10 is as follows.
* A Digital Piano of which firmware is 1.10 is able to read any user data (Stage Setting(.ZPF), Melody Tone(.ZTN), Hex Layer (.ZLT),
Drum Tone(.ZDR), Arpeggio(.ZAR), Phrase(.ZPH), Song(.ZSQ), All data(.ZAL)) which is created by a Digital Piano of which firmware is 1.00.
* A Digital Piano of which firmware is 1.00 is not able to read any user data which is created by a Digital Piano of which firmware is 1.10.
To Next Page
Need help?
General
