E-27
English
Assembling the Stand
PREPARATION
• Before starting assembly, check to make sure that
you have all the parts shown below. You can find
the screws in a plastic bag inside of the polystyrene
foam packing material.
• This stand does not include any of the tools required
for assembly. It is up to you to prepare a large
Philips head (+) screwdriver for assembly.
*CAUTION
• The stand should be assembled by two people
working together.
• The stand should be assembled on a flat surface.
• Do not remove the tape securing the keyboard cover
in place until assembly is complete. Removing the
tape can cause the keyboard cover to open and close
during assembly, creating the risk of personal injury
to your hands and fingers.
• Take care that you do not pinch your fingers
between parts when assembling them.
• When placing the digital piano on the floor, be sure
to place it on something soft (a blanket, cushion,
etc.). Do not place the digital piano directly onto the
floor.
NOTE
• When attaching the digital piano and the back panel
C
to side panels
A
and
B
, lay the entire assembly on
its side.
• Be sure to follow the proper procedure when
assembling the stand.
Unpacking
A
Side panel ........................... ×1
B
Side panel ........................... ×1
C
Back panel .......................... ×1
D
Screws ................................ ×8
E
Screw caps.......................... ×8
F
Pedal unit ............................ ×1
G
Screws ................................ ×2
H
Clips .................................... ×2
I
-(a) Bracket.......................... ×1
I
-(b) Bracket.......................... ×1
J
Screw caps ......................... ×2
K
Joint connectors.................. ×4
L
Polystyrene foam packing
material (Required for stand
assembly.)........................... ×1
A
B
D
E
I
(a) (b)
J
G
H
L
K
F
C
Assembling the Stand
To Next Page
Loading...
Need help?
General
