EN-30
Configuring Settings with the Keyboard
■ Tones
Parameter List
Parameter Settings
Operation
Type
(page
EN-28)
Description Remarks
bp
Hall simulator
Off (OFF), DUTCH
CHURCH to
FRENCH
CATHEDRAL
Default:
STANDARD
HALL
A Specifies the hall simulator of
notes. (page EN-10)
bq
Tone selection
See page EN-7.
Default: GRAND
PIANO
(CONCERT)
A Assigns a tone to the keyboard.
(page EN-7)
br
Chorus
(CHORUS)
Off (OFF), 1 to 4
Default: Off
D Controls the breadth of notes.
(page EN-10)
bt
Brilliance
(BRILLIANCE)
–3 to 0 to 3
Default: 0
B Specifies the brilliance of notes.
Pressing [+] makes notes brighter
and harder. Pressing [–] makes
notes mellower and softer.
• To return the setting to its initial default
(0), press [+] and [–] at the same time.
cn
Layer balance
–24 to 0 to 24
Default: –10
B Specifies the volume balance
between the main tone and the
layered tone. (page EN-9)
• To return the setting to its initial default
(
–10), press [+] and [–] at the same time.
cr
Duet pan Off (OFF), On (ON)
Default: Off
D When turned on, outputs the left
side keyboard tone from the left
speaker and the right side
keyboard tone from the right
speaker while duet is turned on.
(page EN-13)
• Supported only when a piano tone is being
used. Reverb is not applied when this
parameter is turned on.
cs
Bass damper
effect
Off (OFF), On (ON)
Default: Off
D When turned on and the BASS
(LOWER) tone is selected, pressing
the damper pedal or sostenuto
pedal will apply sustained
reverberation to the BASS
(LOWER) tone. (page EN-8)
ct
Damper noise
Off (OFF), On (ON)
Default: On
D Enables/disables damper noise
output. (page EN-12)
PX860-ES-1A.indd 32 2014/06/27 12:26:13
To Next Page
Loading...
