English
Assembling the Stand
E-61
4.
Insert angle brackets H into the gap between
the anti-tipping bracket and the side panel.
5.
From the outside of side panels A and B,
temporarily tighten the screws you loosened
in step 3, above.
6.
Mount pedal unit
E
onto angle brackets
H
,
which you installed in step 5, above.
7.
Use two
F
screws to secure both ends of the
pedal unit
E
to the angle brackets.
8.
Cover the heads of the
F
screws with screw
caps
I
.
9.
After adjusting the position (height) of pedal
unit
E
, fully tighten the screws that you
temporarily tightened in step 5, above.
10.
Mount the piano onto the stand. Position the
piano so the dowels on the top edges of side
panels
A
and
B
enter the dowel holes on the
bottom of the piano.
• Note that there is nothing anchoring the piano to the
stand at this time. Take care to ensure that the piano
does not fall off the stand.
E
PX780_e.book 61 ページ ２０１２年１２月６日 木曜日 午後２時２６分
To Next Page
Loading...
