— 6 —
PROGRAM UPDATE
YES
NO
VER1.001
(5) After a while, display shows “COMPLETE!” and the camera is set in PLAY mode.
(6) Turn the camera off then turn the power key to “PLAY” while pushing “SET” key.
Check the version number on the display.
This time “VER1.001” will be shown.
(7) If the version number is correct, the firmware upgrading is completed.
Turn the camera off.
(8) Take a test picture.
Take one picture and play it back and check the result.
If the picture is normal, delete it and complete the test.
To Next Page
Loading...
Need help?
General
