Casio SE-S3000 - Programming Functions of Departments and PLUs Individually; Programming Department Functions Individually

E-83
Useful features
Advanced programmings and registrations
Programming functions of departments and PLUs individually
Programming functions of departments individually
This part explains programming methods of each function of departments indi-
vidually.
Step Operation
1 Turn the Mode switch to PGM position and select [System
Setting] then press F key.
>▪▪▪▪▪>F
2 Enter 3 and press o key to set the register in the
programming mode.
3o
3 Referring the following table, enter two-digit set code you
wish to program followed by two 6s. The “66” is the identi-
cation code for individual programming of departments and
PLUs. Then press o key.
BB66o
(set code)
4 You can skip this step if you program in departments 01
through 30. If you wish to program in departments 31
through 60, press
DEPT
SHIFT/
DEPT#
key.
DEPT
SHIFT/
DEPT#
5 Referring the following table, enter program code and press
the department key in which you wish to set.
123#
This example is for linking dept. 03 to item
group 123 assuming set code 11 has been
entered in step 3 and
DEPT
SHIFT/
DEPT#
key is not pressed
in step 4.
6 If you wish to set the same function in another department,
press the corresponding dept. key.
$
This example is for setting the same linking
group in dept. 04.
7 Repeat steps 4 and 5 to set another function in another
department.
8 Press o key to complete the program.
o