— 61 —
[ 24 ] Time setting
[ 25 ] Time display
[Function]
This sets the time and date.
When setting the time, the time and date will be displayed without inputting the fixed value.
[Operation]
* Date and time setting
Operation : x1 x2 x3 x4 x5 x6 0 a 7 0 SUBTOTAL
a: 0: time setting x1/x2: time, x3/x4: minutes, x5/x6: second
1: time setting x1/x2: year, x3/x4: month, x5/x6: day
The test will be done one time.
* Date and time display
Operation : 7 0 SUBTOTAL
To stop the operation, press “Esc” key. Date and time will be continuously displayed until “Esc”
is pressed.
[LCD]
When inputting (70#2)
[Print]
The left figure is for date and time display only. When
setting the time and date, each data will be displayed.
Each data will be printed only when setting the date and
time.
DATE/TIME 70
DATE/TIME YY/MM/DD HH:MM-SS
END 70
DATE/TIME 70
DATE/TIME YY/MM/DD HH:MM-SS
END 70
[ 26 ] Drawer open test
[Function]
This test will check the drawer open function.
The test ends by the judgment of the operator either by OK or NG only when the one time check is
selected.
[Operation]
Operation : x n 0 9 1 SUBTOTAL
x: 0 = All drawers open (can be omitted)
1 = Drawer 1 open
(The input numbers, for example, 2 and 3, correspond to the drawer numbers. Up to drawer
4 can be tested.)
n: 0 = One time check (can be omitted)
not 0 = Continuous check (To stop the test, press “Esc” key)
* When the continuous check is selected, the drawer opens every 2 seconds.
* The following “OK” or “NG” key can be used in case of one time check.
”OK” = 1
”NG” = 9
To Next Page
Loading...
Need help?
General
