Casio WK-1500 - Technical Reference: Troubleshooting; Troubleshooting Common Issues

an
Ty
5. FINE TUNE
This
parameter
sets
the
fine
tuning
(detune)
of
each
MIDI
channel.
Normally,
the
COARSE
TUNE
is
made first and then refined with FINE TUNE.
Notes
«
When
you
are
using
the
same
tone
on
two
different
channels,
slightly
detuning
one
of
the
channels
gives
the
tone
more
depth.
The
actual
result
obtained
depends
on
the
tones
you
are
using,
so
try
a
number
of
setting
to
find
the
result
you
want.
*
Using
the
TRANSPOSE/TUNE
button
to
change
the
tuning
replaces
the
settings
made
with
this
parameter.
6. COARSE TUNE
This parameter tunes each MIDI channel.
7. EXPRESSION
This parameter sets the expression of each MIDI channel.
Note
*
VOLUME
and
EXPRESSION
are
basically
the
same
setting.
Normally,
VOLUME
is
used
to
auyusi
the
overall
volume
of
all
channels,
while
EXPRESSION
is
used
to
change
the
intonation
within
a
song.
MIDI channel assignments during data receive
ee ed
fn
few
|
fowew
|
|
[0
[oe
|
0
Highend |Highend |Lowend jLowend
Layer + Split layered tone eee al Chord 1 | Chord2 | Chord3
es
Da
ee
a
ee
sel
Ena
a
TC
[rome
oem
[rvem
[Ot
Ea
a
ae
oe
ay
ee
ae
ee,
pai
a
fe
eo
Layer + Split Rhythm
Note
* MIDI Channels 1 through 3 are used when Magical Preset is being used.
E-84
Technical Reference
Troubleshooting
Probabie Cause
No sound when key- | 1. Power supply problem
board keys are
pressed.
. Make sure the AC adaptor is con-
nected, or that batteries are. not
dead and are loaded correctly (with
+ and - ends facing in the right di-
rections). :
2. Slide the VOLUME controller to-
wards MAX.
3. Disconnect the headphones from
the keyboard.
4. Use the MODE button to turn off
the mode indicators.
. VOLUME is set to MIN.
. Headphones are connected.
. Attempt to play notes on accompa-
niment keyboard while the CASIO
CHORD or FINGERED mode indi-
cator is lit.
. Adrum set (dr.0 to dr.7) is selected.
5. Any of these settings disable the 16
keyboard keys on the far left and
the seven keyboard keys on the far
right.
6. Turn the LOCAL CONTROL param-
eter on.
7. Press the button so the indicator
8
1
. The LOCAL CONTROL parameter
is off,
. Mixer channel? 1 is off.
lights.
. Increase channel 1 volume.
. Use the ACCOMP VOLUME button
to adjust the accompaniment vol-
ume.
2. Tum the rhythm part on.
3. Adjust the rhythm volume.
. Mixer channel 1 volume is set to 000.
. Accompaniment volume is set to
000.
No rhythm sound
. The rhythm part is cancelled.
. The Accompaniment Mixer rhythm
volume is set to 0.
. Accompaniment volume is set to
000.
@ONr
. Use the ACCOMP VOLUME button
to adjust the accompaniment vol-
ume,
. Turn the part on.
No auto-accompani-
ment sound
2. The accompaniment part is can-
celled.
3. The Accompaniment Mixer volume
for the part is set to 0.
. Mixer buttons CH1 through CH4 are
turned off (indicators are not lit).
2. Volume is set to “000”.
3. Adjust the part’s volume.
. Press Mixer buttons CH1 through
CH4 to turn their indicators on.
2. Use the Mixer to increase volume.
Layer and split indi-
cators are lit, but no
sound is produced.
* No pad sound out-
put.
One of the following
symptoms when using
batteries
Low battery power Replace batteries with new ones
@ Dim POWER indicator | © Spontaneous sound out-
@® Low volume put when keyboard keys
@® Sound distortion are not pressed
@ Interruption of sound at @ Tone output different
high volumes from selected tone
© Sudden power outage Abnormal sound during
at high volumes rhythm or demo tune play
E-85