Casio WK-3500 - LCD, Storage, and Tuning Checks

— 19 —
12. LCD check
1 Press “TEMPO쑿” button.
2 Turn on all segments of the LCD.
3 Press “BANK” button.
4 The area 4 turns as check pattern.
5 Press “REGISTRATION 1” button.
6 The area 4 turns as check pattern.
7 Press “REGISTRATION 2” button.
8 Half of characters in area 1 to E turn on.
9 Press “REGISTRATION 3” button.
= Rest of above characters turn on.
A Press “REGISTRATION 4” button.
B Each characters turn in order.
There no lack of dots and characters
13. Card check (If no smart media card, this check can be skipped)
1 Press “-” button.
“Err NO CARD” appears and an NG sound sounds when no card is inserted.
14. Bender check
1 Press “MODE” button.
2 Turn the “PITCH BEND WHEEL” to MAX.
3 Turn the “PITCH BEND WHEEL” to MIN.
15. TUNE check (If no TUNING METER, this check can be skipped)
1 Connect the TUNING METER to the phone jack.
2 Press “CH8” button.
3 The TUNING METER must indicate "C".
4 Disconnect the TUNING METER from the phone jack.
16. APO check
1 Press “EXIT” button.
* Go out from TEST mode (Power off).
* The LCD turns off.
DIAGNOSTIC PROGRAM IS FINISHED.
Message on LCD
Except area 4
Except area 4
4 SMC CHK
앗
4 CARD OK
4 BEND CHK
2 127
4 BEND CHK
2 000
4 BEND OK