E-17
Getting Ready
English
z You can use the projector to project an image of video output from a computer.
z You can also output audio from the computer through the projector’s speaker.
z After you connect a computer to the projector’s USB port, you can use the remote controller
to perform computer mouse operations, and previous page and next page operations.
z Always turn off the projector and the computer before connecting them.
You can use the projector to project an image from a video deck, TV, video camera, or other
video device. You can also output audio from the video device through the projector’s speaker.
z Always turn off the projector and the video device before connecting them.
z You can use the bundled video cable to connect to a pin jack (RCA) type VIDEO output
terminal. When connecting a video camera or other video device with a special video output
terminal, use the special cable that comes with the video device. For details, see the
documentation that comes with the video device.
z Note that the projector is equipped with separate circuits for the VIDEO input terminal and
S-VIDEO input terminal. Make sure you connect the video device to the correct terminal.
The projector lets you switch the input source between RGB (or Component), VIDEO, and
S-VIDEO whenever you want.
Connecting a Computer to the Projector
Connecting to a Standard Video Device
RGB input
terminal
AUDIO input terminal
Projector
Audio cable (commercially available)
Computer
Bundled mini D-Sub cable
To monitor terminal (analog RGB output terminal)
To line output terminal
USB Port
Bundled USB cable
To USB port
Projector
Video device
Commercially available audio cable
Bundled video cable
AUDIO input terminal
S-VIDEO input terminal
VIDEO input terminal
To VIDEO output terminal
To AUDIO output
terminal
To S-VIDEO output terminal
Commercially available
S-video cable
To Next Page
Loading...
Need help?
General
