E-3
Safety Precautions
● Disposal by burning
Never try to dispose of the projector by
burning it. Doing so can cause an
explosion, which creates the risk of fire
and personal injury.
● Looking into the lens or vents while
light source unit is on
Never look directly into the lens or vents
while light source unit is on. The strong
light emitted by the projector creates the
risk of eye damage.
● Blocking the vents
Never allow the vents to become
blocked. Doing so causes internal heat
build up, which creates the risk of fire and
breakdown of the projector. Touching the
projector while it is hot creates the risk of
burn injury. Make sure that you always
observe the following precautions.
• Allow at least 30cm (11.8 inches) between the
projector and walls.
• Do not insert the projector into any space where
air circulation is poor.
• Never cover the projector with a blanket or any
similar item.
• Locate the projector on a firm, flat surface during
use. Never use the projector while it is on a
carpet, blanket, towel, seat cushion, or other
pliable surface.
• Never stand the projector up on either end during
use.
● Projector cabinet
Never open the projector’s cabinet.
Doing so creates the risk of electric
shock.
● Cleaning
Before cleaning the projector, be sure to
turn it off and unplug it from the power
outlet. Failure to do so creates the risk of
electric shock.
● Exhaust vents
The exhaust vents become very hot while the
projector is running. Never touch them. Doing so
creates the risk of burn injury. The areas near the
exhaust vents also become quite hot. Never locate
objects made of plastic or other heat-sensitive
materials near or under the projector. Doing so
creates the risk of deformation and discoloration of
the object.
● Lens cover
Be sure to remove the lens cover before turning on
the projector. Never leave the lens cover attached
while the projector is in use.
● Location
Never locate the projector in any of the following
types of locations. Doing so creates the risk of fire
and electric shock.
• Near an area subject to strong vibration
• An area subject to large amounts of moisture or
dust
• In a kitchen or other area exposed to oil smoke
• Near a heater, on a heated carpet, or in an area
exposed to direct sunlight
• An area subject to temperature extremes
(Operating temperature range is 5°C to 35°C
(41°F to 95°F)).
● Heavy objects
Never place heavy objects on the projector or
climb on top of the projector. Doing so creates the
risk of fire and electric shock.
● Water
Never locate the projector in a bathroom or
anywhere else there is the chance that it will be
splashed with water.
● Unstable location
Never place the projector on an unstable
surface or on a high shelf. Doing so can
cause it to fall, creating the risk of
personal injury.
-
-
-
’
$
-
To Next Page
Loading...
Need help?
General
Weight and Dimensions
