I-4. Disconnect the two connectors and remove the LSB module.
Connector (thermal module)
Lens
Wire (black)
Connector (Module LSB)
<ASSEMBLY NOTES: LSB MODULE>
Wire (red)
XJ-A240/A245
When assembling the LSB module, arrange the cables carefully.
• When attaching the connector of the LSB module (thermal module), make sure that it is oriented correctly.
• Arrange the cables of the LSB module and the cables connected to the back of the PWB-1 board and fix them with tape
in two places. After connecting the FFC cable, secure the cables with a cable tie. NOTE: Be careful not to run
cables on the heatsink. • Arrange the cables of the LSB module (thermal module) and
fix them with tape in one place. NOTE: Make sure the cables do not touch the side of the radiator.
Pass the cables
(thermal module)
through the slot in cover B.
Pass the cables and the FFC
cable through the slot in cover
B and secure them with a
cable tie.
Position the
cables so that they
run around the
screw.
When laying cables, these
areas must be free.
When laying cables, make sure
that they do not get into the
fan area.
-27-
Machine Translated by Google
To Next Page
Loading...
