CASK ACS V4.2 - D.8 Adjustment & Troubleshooting

www.cask.com
+1-800-661-8443
Third Edition, Nov 2016
ACS V4.2
Page | 27
Section D. ACS System Operations
D.8 Adjustment & Troubleshooting
D.8.1 Lid Dispenser Adjustment & Troubleshooting
Tools Required
 7/16 wrench
D.8.1.1 Problem #1
Symptoms
 Lid not releasing from bottom of slide correctly.
 Lids not catching can.
 Lids not automatically refilling.
Adjustment Points
 If cans tip over after lid application, loosen rubber band tension.
 If can lids drop frequently with no cans in place, tighten rubber band.
 Figure 23 shows set bolts for adjustment of can lid dispense height.
 Set screws under the retaining bars.
Figure 23 Setting bolts to adjust can lid dispenser height
1