98
ASSEMBLY
—
BASE ASSEMBLY
—
BASE
Insert the AC cord into the power supply.
IMPORTANT: DO NOT PLUG THE BED
INTO THE AC OUTLET YET.
Insert the legs into the threaded holes
at each corner of the bed by inserting
the leg and rotating clockwise until
tight. There must not be any gap or
wobble in the leg in order to avoid
risk of injury or damage to the bed
which may void the warranty.
Remove the mattress retainer bar
from the bottom of the bed. Finish
removing the plastic packaging from
the bed to orient into final position.
Carefully rotate the bed on its side,
then lift and place on legs.
IMPORTANT: DO NOT LEAN THE BED
AGAINST THE INSTALLED LEGS TO
TURN OVER.
Insert the mattress retainer bar
upright as shown.
Insert the retainer clip securely.
Insert one end of the DC cord into
the power supply. Insert the other
end with locking clip into the cable
coming from the head motor. Lock
the conection using the locking clip.
TO LINK REMOTE
If the remote is not linked, see page .
Locking
Clip
To
Motor
To Next Page
Loading...