Cassida C200 coin counter/sorter/wrapper
Moving money forward
16
Most operational problems can be avoided with regular care and preventive
maintenance.Takingregularcareofyourcoinsorterwillsignicantlyincreaseits
lifetime and help you avoid costly repairs.
IMPORTANT: You should always turn the machine off and disconnect the
power cord before cleaning the machine.
To get the best results out of your machine, the following maintenance is
recommended on a regular basis:
• Clean all external parts of the machine with a Cassida air duster or a soft
cloth. Do not use solvents, as they may damage the C200.
• Clean all the sensors using the procedure described below:
1. Remove the three housing screws and carefully lift up the housing.
2. Clean all sensors and other dusty parts using a Cassida air duster followed by a
CleanPro swab. See Figure 6 for sensor locations.
3. Replace the housing. The housing must be properly lined up with the AC power
cord at the back of the machine. Do not force the housing into place, as this
could damage the coin feed mechanism built into the housing.
3.1 Maintenance
MAINTENANCE AND TROUBLESHOOTING
3.
17
E1
E2
E3
E4
E5
E8
E7
E6
Figure 6 - Sensor locations
Clean all sensors and other dusty parts using compressed air or a soft bristle
brush
running sensor counting sensor
To Next Page
Loading...
Need help?
General
