11. Clean the dust from the distribution wheel and sensors using an air duster. Spray the air duster from left to
right with a rotative circle as shown below. Intensify the spraying around sensors.
* Be cautious and always keep the nozzle 1-2 inches away from the unit.
Cassida Corporation • 11035 Technology Place, Suite 500 San Diego, CA 92127 • www.CassidaUSA.com
©2019 Cassida Corporation. All rights reserved. Specifications subject to change without notice. Cassida is a registered trademark of the Cassida Corporation.
REV0919
Coin Presence
Sensor
(Intensify spraying
under the sensor)
9. Check if the sensors are aligned, if not, gently straighten them up. Too much force can damage the sensors.
EA ERROR TROUBLESHOOTING
10. Inspect the interior of the machine. Remove coins or any other foreign objects that may be preventing the coin
platter from rotating.
C300
Cleaning Procedure
To Next Page
Loading...
Need help?
General
