Cateye Micro CC-6000 - How to read data; Reading Basic Data; Applying Data for Riding

m How to read data
Basic Data
(a) Check that the speed scale symbol (mile/h or km/h) or the cadence scale symbol (rpm) does not flicker. (Set the operation on stop.)
(b) Select any other mode except total distance (ODO), and press the mode button and start/stop button simultaneously. (Maximum
speed) (MXS), trip distance (DST), average speed (AVS) and elapsed time (TM) should be zero.)
(c) Press the start/stop button when starting.
(“mile/h (Km/h)" or “rpm" (in the cadence mode) will flicker.)
(d) Press the start/stop button when reaching your destination, (When the speed scale symbol or cadence scale symbol stops flickering,
the unit enters the stop state.)
(e) Press the mode button to read the data.
Application of data
(a) To accumulate actual trip data during riding, the rest time can be eliminated by pressing the start/stop button before and after resting.
(b) To accumulate lap time and maximum speed data on a track, press the start/stop button when passing the start line and again, when
passing the finish line.
-17-