NVE902 H.264 HD Network Encoder User Manual
Device IP Address: To view or set the IP address of device.
User can set custom IP address of device. The default IP address of device is
192.168.1.12.
Subnet Mask: To view or set the subnet mask of device.
User can set custom subnet mask of device. The default subnet mask of device is
255.255.255.0.
Gateway: To view or set the gateway of device.
User can set custom gateway of device. The default gateway of device is
192.168.1.1.
DHCP: To view or select open DHCP or not.
Disable: Close DHCP; Enable: Open DHCP。
Video Input: To view or select the video input.
SDI: SDI video input; HDMI: HDMI video input; CVBS: CVBS signal input;
Video Rate: To view or set the video bit rate.
User can set custom video bit rate.
Video Status: To view the status of video input.
Audio Input: To view or select the audio input.
SDI: SDI audio embedded input; HDMI: HDMI audio embedded input; Analog:
Analog audio input;
Audio Rate: To view or set the audio bit rate.
User can set custom audio bit rate.
Audio Status: To view the status of audio input.
Stream Status: To view the status of video/audio encoding.
Recovery: To recover to the default setting.
NO: Not to recover; YES: Recover to the default setting.
7
To Next Page
Loading...