DAILY MAINTENANCE
TO BE CARRIED OUT BY INSTRUCTED SURGERY STAFF
CLEANING THE INLET DEBRIS FILTER
Inlet debris filter location:
Instructions for cleaning:
1. Turn the power off to the suction system.
2. To remove the filter from its housing, twist anti-clockwise and
pull. It is recommended that you collect the waste material
from the filter as it contains amalgam. This can be done by
tapping the filter and allowing waste material to fall into an
appropriate container and safely stored for later collection
by an approved recycling company.
3. Brush and rinse filter with clean water to shift any stubborn matter from the filter. Ensure the
brush has not been used with any other chemical or detergent. DO NOT use any detergent or
disinfectant to clean the filter – simply empty it and rinse with water.
4. Wipe the outside of the filter basket and the inside of the filter housing, especially around the
rubber o-ring seal, to clean away any gritty material.
5. Apply Lubri Jet drop or spray lubricant to the rubber o-ring, work it around the entire o-ring and
then reinstall the filter into its housing.
6. After the filter is reinstalled, check that the o-ring seal is seated properly and not bulging out in
any place as this may cause a fluid leak. If the o-ring is bulging, swollen or shows signs of wear,
contact your equipment service technician for replacement.
7. Turn the power back on to the suction system.
CLEANING THE ASPIRATION FILTERS
It is recommended that you clean the filters on the dental unit
and replace the Antifoaming Tablets (if used).
MICRO SMART MICRO SMART CUBE TURBO SMART TURBO SMART CUBE MAXI SMART
To Next Page
Loading...
