CBE PRM350 - Prm3 0 5 Solar Charge Regulator; Overview

13
Selector on position “A”
Max 14,1V
Max 14,4V
Max 14,7V
1h
4h
2h
13,5V
13,8V
13,8V
Selector on position “B”
Selector on position “C”
The position of the selector must be set according
to the ingmost suitable charg voltages for the
type of battery installed.
for led- batteries, position for le d-gel
batteries position for AGM batteries
acid on a« »B
, on and on
position for lithium batteries.
« »C
«Li»
I onn most cases, the selector can be set position A« »
1 2 3
Max 14,6V
max 1h
13,8V
Selector on position “Li”
Soglia limite
Line «A» Line «B» Line «C» Line «Li»
OVERVIEW
Note: of- the end- charge voltage is reached
only if the battery is efficient.
Phase 2: -Absorption battery charging at costant
of-
,
until the charging is
completed.
end- charge voltage for the time defined
by the charging line with a progressive
current reduction
Phase 1: battery charging with maximum
current until the end- charge voltage is
reached.
Bulk -
of-
3 phase automatic charging system
Phase 3: -Float Maintenance charg at constant
voltage. igh lead to phase
starting again.
ing
A h load s Bulk
“PRM3 0” 5 SOLAR CHARGE REGULATOR
EN
The PRM3 0 charge regulator can charge lead
(liquid, gel and AGM) and lithium 12V batteries
5 solar
automatically c and limiting the energy
supplied by the connected photovoltaic modules.
ontrolling
It a MPPT (Maximum Power Point Tracker)
system that allows picking in every situation of the
maximum power supplied by the photovoltaic
module.
features
The PRM3 0 is suitable for operation with 32 to 72-
cell photovoltaic modules up to a maximum power of
3 0W.
5
5
For optimal performance, you are advised to connect
the photovoltaic modules with a number of cells over
36, independent of the type of installation chosen (see
the “CONNECTIONS” paragraph).
CHARGE LINE SELECTOR.
3
2
1
3
2
1
3
2
1
3
2
1