16
Default: All the Junction Lines land on Extension number 6001 and 6002 in Simultaneous Mode.
. Junction Line - Enable / Disable .
If less than 3 Junction lines are connected to the system then lock the unused Junction Line.
Procedure:
To Enable one Junction Line at a time, Dial #0000 + 060 J #
Here, J = 1, 2, 3, 4, 5, 6, 7 or 8 representing the 8 Junction Lines
To Disable one Junction Line at a time, Dial #0000 + 061 J #
Here, J = 1, 2, 3, 4, 5, 6, 7 or 8 representing the 8 Junction Lines
Note : In default all Junction Lines are Disabled.
. Junction to Junction Forwarding (Optional) .
There are 2 types of Junction to Junction Transfer:
1. Incoming Junction Call on Ext to be transferred to another Tel Number/Cell number.
2. Making 2 Junction lines talk to each other while Ext remains out of the conversation.
Incoming Junction Call on Ext to be transferred to another Tel Number/Cell number
Any of the Extension can feed in a Telephone Number or Cell number on its extension whereby the incoming calls on its
extension would get diverted to those numbers.
While talking a tone will be heard after 2 minutes and if is pressed then the call would get extended for another 2
minutes. Like this user can keep extending the talk time. If is not pressed then the calls will disconnect. If user wishes to
disconnect in between then # need to be pressed.
Programming:
Dial from your own Extension #84* Tel No (where calls are to be diverted to) #
Increasing or decreasing the Talk time in such forwarded calls:
#84TT
Where, TT= 01 to 99.
In default TT = 09 x 10 = 90 Secs (80 secs talk time and 10 secs Alert Time)
To cancel the feature, dial from your own Extension #84#
Making 2 Junction lines talk to each other while Ext remains out of the conversation.
Process: During conversation with a Junction line - Hook-Flash - #6 (To park the Call) – 0 – Tel No (who is to
be connected to the previous Junction call) – Hook Flash - # - Now all 3 party can talk to each other.
but Ext can keep Handset down. The 2 Junction lines will hear a tone after 2 minutes and if any of them
presses * then they can talk for another 2 minutes. Like this they can keep extending the talk time. If * is
not pressed then the calls will disconnect. If they wish to disconnect in between then any of them need to
dial #.
. KTS Enable/ Disable
To enable KTS, do following programming:
Dial # * 0000 29 K N #
Where, K= KTS Number (1-8)
N= 0 to Disable
1 to Enable
. KTS DSS Key Setting
DSS Keys of KTS are programmable, they can be used as one touch CO access or Ext dialing.
To set CO Key as ext, Dial: #*0000+ 23 K NN XXX#
To set CO Key as Junction, Dial: #*0000+ 23 K NN J#
To reset all CO keys of KTS ‘K’, Dial: #*0000+ 23 K#
To clear particular CO Key of KTS ‘K’, Dial: #*0000+ 23 K NN#
Where K = 1-8 (KTS number)
NN = 01-12 (CO number)
XXX = 01-120 (Ext number)
Default: All Keys are for Junctions
. KTS Call Details
The incoming and outgoing call record of KTS can be viewed from the KTS. System stores 10 outgoing and 10 incoming
call details for each KTS.
Outgoing Call Details
With KTS on-hook, press key ‘2’
Incoming Call Details
With KTS on-hook, press key ‘8’
To Next Page
Loading...
