5
Please note:
• Under no circumstances should the extractor be
connected to any gas ventilation system, flue system or
hot air ducting system.
• Do not vent the extractor into an attic or loft space.
• Only house the extractor in rooms with adequate
ventilation. Remember that the extractor is powerful and
whatever air is extracted needs to be replaced.
• Do not tile the extractor in. It should be removable for
service or maintenance.
• Do not use silicone sealant to secure the hood to the wall.
• You must be able to isolate the extractor from the mains
electrical supply after installation.
• This extractor has been designed to be used in a room
with a volume of less than 36m
3
.
• Steam cleaners must not be used when cleaning this
appliance.
• The performance of your extractor will vary depending on
a number of factors. These include type of extraction,
length of ducting, room volume, ventilation available and
cleanliness of the filters.
To Next Page
Loading...
Need help?
General
