9
Changing a light bulb
DO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS
THE BULB WILL BE HOT. ALLOW IT TO COOL BEFORE REMOVING
IT.
Remove the grease filter, unscrew the light bulb and replace the light
with the required light bulb as shown below. Finally, replace the
grease filter.
The ECH extractors are designed for 3W maximum LED 2 pin GU10
bulbs.
Do not touch bulbs or adjacent areas during or straight after pro-
longed use of the lights.
The light is designed for use during cooking and not for general room
illumination. Extended use of the light can reduce the life span of the
bulb.
Bulb replacement is not covered by the guarantee.
Only use bulbs recommended for your extractor. Do not fit bulbs of a
higher power rating. Bulbs of a lower power rating may be adequate
for use, generally last longer and use less energy.
Spare bulbs are available from CDA Customer Care or from your local
DIY shop.