5
Changing the Light
IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING
OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE
ELECTRICITY SUPPLY.
DO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS
THE BULB WILL BE HOT. ALLOW IT TO COOL BEFORE REMOVING IT.
Carefully prise open the lamp assembly cover (D) using a small, flat-bladed
screwdriver and remove the old bulb (C). Refit the new bulb taking care not
to touch the glass of the bulb (Fingerprints will lead to premature failure of
the bulb)
Do not touch bulbs or adjacent areas during or straight after prolonged use
of the lights.
The light is designed for use during cooking and not for general room
illumination. Extended use of the light can reduce the life span of the bulb.
Bulb replacement is not covered by the guarantee.
Only use bulbs recommended for your extractor. Do not fit bulbs of a higher
power rating.
Bulbs of a lower power rating may be adequate for use, generally last longer
and use less energy.
Fig. 3
C
D
Model Lightbulbs required
ECHK/ECPK 12V G4 type
To Next Page
Loading...
Need help?
General
