23
Synchronising the remote control with the extractor
When the extractor is o, press and hold button B, and then switch the
extractor on.
After five seconds release button B and the display will light up in
sections. Then press button E.
TC will flash twice to confirm the remote is synchronised.
TC will flash once to confirm the remote is not synchronised.
To change the battery
The remote control is powered by two standard LR03-AAA batteries.
To open the battery compartment, slide the rear panel down and then
lift the panel.
To replace the rear panel, locate the panel over the battery
compartment then slide the panel up until it clicks.
To Next Page
Loading...
