EasyManua.ls Logo

CDA EVX100

CDA EVX100
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Changing the Light
IMPORTANT: DO NOT PERFORM MAINTENANCE OR ATTEMPT
TO CLEAN THE EXTRACTOR WITHOUT FIRST SWITCHING OFF
THE ELECTRICITY SUPPLY.
DO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS
THE BULB WILL BE HOT. ALLOW TO COOL BEFORE REMOVING.
1. Unfasten the sliding brackets on either side of the cover panel and
the cover panel will hinge open.
2. Remove the faulty light bulb and replace with a light bulb no more
powerful than that specified on the rating plate.
3. Replace the cover panel and refasten the sliding brackets.
Do not touch bulbs or adjacent areas during or straight after
prolonged use of the lights.
The light is designed for use during cooking and not for general room
illumination. Extended use of the light can reduce the lifespan of the
bulb.
Bulb replacement is not covered by the guarantee.
Only use bulbs recommended for your extractor. Do not fit bulbs of a
higher power rating. Bulbs of a lower power rating may be adequate
for use, generally last longer, and use less energy.
Spare bulbs are available from CDA Customer Care or from your local
DIY shop.

Related product manuals