7
- To activate the clean air function, touch key E when the appliance is
either on or o. When the clean air function is running, 24 will show
on the display and a dot will flash in the lower right hand corner of
the display when the motor is running
- To cancel the clean air function, touch any key except the light key.
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR ATTEMPT
TO CLEAN THE EXTRACTOR WITHOUT FIRST SWITCHING OFF
THE ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including
Cif) will scratch the surface and could erase the control panel
markings.
You can clean your extractor eectively by simply using a dilute
solution of water and mild detergent and drying to a shine with a
clean cloth.
Cleaning the grease lter
The grease filter should be kept clean to minimise the risk of fire.
After 100 hours of use, FF will show on the display when the extractor
is switched o. This indicates that you should remove and clean the
grease filters with hot soapy water. You can also wash the grease
filters in a dishwasher, ensuring that you place it in an upright position
to prevent damage from other items in the dishwasher. After rinsing
and drying, replace the filter.
To Next Page
Loading...
