27
400. Secure the mounting bracket to the fascia panel using the
provided wood screws, ensuring that the screws will not penetrate
through the fascia where there are any rebates, etc. and then
remove the guides. Any small errors, as in the image above, can be
adjusted for after the fascia has been mounted.
5. Hang the fascia panel on the support pins and check that the fascia
is positioned correctly. Adjustments can be made in all directions
at this stage using the adjustment points shown in figure 26.
Loosening this screw allows the fascia panel to be moved closer to
or further away from the door.
The left right and vertical position can be set using this screw. Insert
a screwdriver in the slot at the top and move up (anti-clockwise) or
down (Clockwise). Simply slide the bracket left or right to fine tune
the horizontal position of the fascia.
6. To fit the lower fascia support brackets , secure each of them to
the underside of the door with a single screw. At this stage do not
fully tighten to allow adjustment to be made after the door is fixed
in place. The fascia panel can then be secured to the bracket using
two of the supplied wood screws. Finally, fully tighten the bracket
mounting screw to fix the bracket at the required position and fit the
cover trim pieces for the fascia mount brackets, as shown in figure
27.
To Next Page
Loading...
