14
Code Potential cause Potential solution
F3/F4
Induction coil
temperature sensor
failure
Contact CDA Customer Care to
arrange a service visit.
F9/FA
IGBT temperature
sensor failure
Contact CDA Customer Care to
arrange a service visit.
E1/E2
Abnormal supply
voltage
Incoming mains voltage needs to be
inspected for abnormalities (below
220V or above 240V). Restore power
to hob if between these parameters.
E3
Over-temperature
at the induction
temperature sensor
Contact CDA Customer Care to
arrange a service visit.
E5
Over-temperature
at the induction
temperature sensor
Restart the hob after it has been given
time to cool down
9 fast frying steaks
If your hob is not working:
1. Check that the zone is switched on.
2. Check that the mains supply has not been switched o.
3. Check that the fuse in the spur has not blown.
In the event of an unsolvable fault with the hob please advise CDA
Customer Care.
Contact CDA Customer Care
A: Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T: 01949 862 012 F: 01949 862 003
E: customer.care@cda.eu W: www.cda.eu
Troubleshooting - fault/error codes
To Next Page
Loading...
