43
Electrical installation
For your safety please read the following information:
IMPORTANT: The cooker must be installed in accordance with the manufacturer’s instruc-
tions.
Incorrect installation, for which the manufacturer accepts no responsibility, may cause
damage to persons, animals or equipment.
General
– Connection to the mains must be carried out by qualified personnel in accordance with
current regulations.
– The appliance must be connected to the mains checking that the voltage corresponds to
the value given in the rating plate and that the electrical cable sections can withstand the
load specified on the plate.
– The appliance can be connected directly to the mains placing an omnipolar switch with
minimum opening between the contacts of 3 mm between the appliance and the mains.
– The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 75°C at any point.
– Once the appliance has been installed, the switch or socket must always be accessible.
– If the power supply cable is damaged it must be substituted by a suitable cable.
N.B. For connection to the mains, do not use adapters, reducers or branching
devices as they can cause overheating and burning.
If the installation requires alterations to the domestic electrical system, call an expert.
He should also check that the socket cable section is suitable for the power absorbed by
the appliance.
The connection of the appliance to earth is mandatory.
The manufacturer declines all responsability for any inconvenience resulting from the inobser-
vance of this condition.
To Next Page
Loading...
Need help?
General
