13
This oven’s electronic timer is equipped with touch control sensors.
Each registered touch of a sensor field is confirmed by a single beep.
It is advisable to keep the sensor fields clean at all times to avoid
errors in operation.
Setting the current time
After connection to the mains supply, or re-connection after a power
outage, the display will show ‘12.00’ and the clock symbol will flash.
• Set the current time using the and sensors. After an
approximately 5 second wait, the time will be set.
• The time can be amended at any time by following these steps.
However, you will firstly need to press until the display shows
the flashing symbol.
Please note: The time must be set for the oven to work.
Setting the minute minder function
The minute minder function can be set at any time, regardless of the
state of activity of the oven. The minute minder can be set anywhere
from 1 minute to 23 hours and 59 minutes.
• Press
until the display shows the flashing symbol.
• Set the desired duration of the minute minder using the and
sensors. After an approximately 5 second wait, the minute
minder will be set and the symbol will be solidly lit.
• Press any of the three sensors in order to deactivate the acoustic
signal that sounds once the minute minder time has elapsed. The
timer will then revert to showing the current time.
To Next Page
Loading...
