16 | Instruction Manual
Pyrolytic cleaning
This function heats the oven to approximately 480°C which will burn
o or loosen any stubborn grease, stains or dirt inside the oven,
leaving behind an ash that simply has to be wiped up or swept from
the interior afterwards.
The cleaning process
• Remove all items from the oven (baking trays and side racks) as
these can be damaged during the process
• Close the oven door
• Set the function selector knob to the position
• Pyrolytic cleaning duration (
P2.00
) and the symbol will show on
the display. The door indicator light will come on
• Touch for approximately 3-4 seconds until the display shows
0:00
• Touch again, the display will flash
Pdur
• Touch the
/
sensors to select the duration. You can choose
2 hours, 2 and a half hours or 3 hours. Once you have made your
choice, wait for the beep which confirms the duration has been set
• The cleaning process will start and the oven will be locked
•
P0.00
will show on the display once cleaning is complete
• The door will remain locked until the oven chamber cools down to
160°C. Once the temperature is reached the door will be unlocked
and the door lock indicator light will go out
• When the door lock indicator light is o set the function selector
knob to
• When the door is unlocked and you turn o the oven, you can
remove ash from the oven chamber with a soft, damp cloth
• Replace the the side racks and other accesories and your oven is
ready to use
To Next Page
Loading...
