User instructions
10
After using the table to identify the most appropriate washing program:
• press the ON/OFF button (1) and wait for the PROGRAM
INDICATOR LIGHT (2) to illuminate;
• keep pressing the PROGRAM SELECTION button (3) until the
indicator light corresponding to the desired program illuminates;
• close the door; after about 2" the program will start. While it is in
progress, the relative LIGHT will flash (indicating that the program is
being executed).
DURATION
CONSUMPTION
PROGRAMME,
NUMBER & SYMBOL
LOAD CROCKERY
AND CUTLERY
PROGRAM
PROGRESS
MINUTES
(2)
WATER
LITRES (1)
POWER
KWh (2)
1
SOAK
Pans and dishes
awaiting
a further wash
Cold prewash
9' 5 0,02
2
SHORT
Delicate dishes, with
light dirt, washed
immediately after
use.
Wash at 38°C
Cold rinse
Rinse at 58°C
45' 13 0,85
3
ECO (*)
EN 50242
Dishes with normal
dirt, washed
immediately after
use.
Wash at 55°C
Cold rinse
Rinse at 66°C
Dry
175' ** **
4
NORMAL
Dishes with normal
dirt, even with dried-
o residues.
Cold prewash
Wash at 65°C
Cold rinse
Rinse at 70°C
Dry
80' 17 1,20
5
ULTRA
CLEAN
Very dirty pans and
dishes (except
delicate items)
Prewash at 45°C
Wash at 70°C
2 cold rinses
Rinse at 70°C
Dry
105' 20 1,50
Only run the soak program with half loads.
The options cannot be used with the soak program.
The "ULTRA CLEAN" program terminates with an anti-bacteria rinse that ensures a further
reduction in the bacteria level. If the temperature falls during this stage of the program (e.g.
because the door is opened or due to a power blackout), the program lights (2) flash to warn
that the anti-bacteria effect is not guaranteed.
(*) Reference program as per EN 50242 standard. (**) See energy label.
(1) Average power consumption with the softener set on level 2.
(2) The cycle duration and power consumption may vary according to the water and room
temperatures, and the type and amount of dishes.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
To Next Page
Loading...
Need help?
General
