How to fix a CDA CDI6121 Dishwasher that won't start?
If the CDA Dishwasher programme won't start, check the following: ensure the plug is correctly inserted, the fuse is intact, and the circuit breakers of the mains supply are functioning. Also, make sure the water tap is turned on and that the dishwasher door is fully closed. Finally, verify that the water inlet filter and the machine filters are not blocked.
What to do if water remains in CDA Dishwasher after cycle?
If water remains inside your CDA Dishwasher after a programme finishes, it could be due to a blocked or kinked water drain hose. Another possible cause is that the filters are blocked.
Why does my CDA CDI6121 stop in the middle of a cycle?
Your CDA Dishwasher might stop mid-cycle due to a power failure, a water inlet failure, or because the programme is on standby.
What to do if the CDA CDI6121 Dishwasher door won't close?
If the door of your CDA Dishwasher isn't opening or closing correctly, it is possible that the door tension has not been correctly adjusted for the decor door.
Why is the wash performance of my CDA CDI6121 so low?
If the wash performance of your CDA Dishwasher is not up to standard, the issue could stem from several factors. Poor loading of dishes might be hindering proper cleaning. Ensure you're adding a sufficient amount of detergent and selecting an appropriate wash programme. Check if the spray arm is blocked, and inspect the filters to ensure they are not clogged or incorrectly fitted. A blocked water drain pump could also be the cause.
Why aren't the dishes dry after CDA Dishwasher cycle?
If your dishes are not completely dry after a CDA Dishwasher programme, it could be because you selected a programme without a drying stage. The rinse aid setting might also be too low. Also, ensure you allow sufficient time for drying before unloading the dishes.
How to remove rust stains on dishes from CDA CDI6121?
If rust stains appear on dishes in your CDA Dishwasher, ensure different sets of cutlery are kept separate. Too much salt, caused by a water softener setting that is too high, can also lead to rust. Check that the salt compartment cap is completely closed and verify that there is a proper appliance earth by checking the mains electrical supply.
General| Door color | Black |
|---|---|
| Water fill | Cold |
| Cord length | 1.65 m |
| Control type | Buttons |
| Display type | LED |
| Product size | Full size (60 cm) |
| Certification | WEEE |
| Built-in display | Yes |
| Inlet hose length | 1.47 m |
| Number of baskets | 2 basket(s) |
| Custom panel-ready | No |
| Outlet hose length | 2 m |
| Appliance placement | Fully built-in |
| Cutlery compartment type | Basket |
| Cycle time | 221 min |
| Noise level | 49 dB |
| Drying system | Active ventilation |
| Delay start (max) | 19 h |
| Dishwashing programs | Eco, Hygiene, Pre-wash, Quick |
| Number of place settings | 13 place settings |
| Number of washing programs | 5 |
| Connected load | 1900 W |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
| Energy efficiency scale | A to G |
| Power consumption (off) | 0.5 W |
| Power consumption (left-on) | 1 W |
| Water consumption per cycle | 9 L |
| Energy consumption per cycle | 0.937 kWh |
| Package depth | 661 mm |
| Package width | 644 mm |
| Package height | 851 mm |
| Package weight | 31300 g |
| Country of origin | Turkey |
| Customs product code (TARIC) | 8422110000 |
Weight and Dimensions| Depth | 550 mm |
|---|---|
| Width | 598 mm |
| Height | 820 mm |
| Weight | 29700 g |
Details on the appliance rating plate for reference and guarantee purposes.
Switches the dishwasher power on or off. Displays two dashes when on.
Selects alternative programmes; stores the last used programme.
Instructions on how to open, fill, and close the detergent compartment.
Guide to filling the salt compartment, including initial water filling.
Steps to use a test strip to determine water hardness level.
Table and procedure for adjusting water hardness level from L1 to L6.
Instructions for adjusting the upper basket height using retaining clips and wheels.
Specifies place settings, upper basket position, and cup placement.
Details on detergent and rinse aid amounts and dosage adjustments.
Information on the standard Eco 50°C programme test parameters.
Advice on cleaning dishwasher door seals with a damp cloth.
Procedure for cleaning the microfilter, coarse filter, and base filter.
Guidance on safely connecting a suitable alternative plug if needed.
To Next Page
