How to fix CDA Dishwasher when the programme will not start?
If your CDA Dishwasher programme won't start, check the following: * Ensure the plug, fuse, and circuit breakers of the mains supply are working correctly. * Make sure the water tap is turned on. * Verify that the dishwasher door is fully closed. * Check if the water inlet filter or the machine filters are blocked.
What to do if my CDA Dishwasher stops in the middle of a programme?
If your CDA Dishwasher stops mid-cycle, it could be due to a power failure, water inlet failure, or the programme being on standby.
How to remove white stains on dishes from CDA wc431?
If you notice white stains on dishes from your CDA Dishwasher, consider these solutions: * Increase the amount of detergent used. * Adjust the rinse aid setting to a higher level. * Add sufficient dishwasher salt. * Increase the water softener setting. * Ensure the salt compartment cap is completely closed.
What to do if water remains inside CDA wc431 at the end of the programme?
If water remains inside your CDA Dishwasher after the programme ends, check if the water drain hose is blocked or kinked, or if the filters are blocked.
Why is the wash performance of my CDA wc431 Dishwasher of a low standard?
If the wash performance of your CDA Dishwasher is not up to standard, consider the following: * Ensure dishes are loaded properly to not hinder wash performance. * Add sufficient detergent. * Select the appropriate wash programme. * Check if the spray arm is blocked. * Make sure filters are not clogged or incorrectly fitted. * Verify that the water drain pump is not blocked.
Why are the dishes not completely dry at the end of a CDA wc431 programme?
If your dishes are not completely dry after a CDA Dishwasher cycle, it could be due to selecting a programme without a drying stage, the rinse aid setting being too low, or unloading dishes too soon. Allow sufficient drying time.
How to get rid of rust stains on dishes from CDA Dishwasher?
If you see rust stains on dishes from your CDA Dishwasher, keep different sets of cutlery separate. Also, ensure you are not using too much salt (the water softener setting is too high) and that the salt compartment cap is completely closed. Finally, check the appliance earth (mains electrical supply).
Steps for initial setup: salt, rinse aid, and running a hot program.
Instructions for adding detergent to main and prewash compartments.
Step-by-step guide for filling the salt compartment.
How the system reduces water hardness for better efficiency.
Steps to adjust the water hardness level using control buttons.
How to fill the rinse aid dispenser correctly.
How to adjust the rinse aid level based on dish results.
Step-by-step guide to cleaning the dishwasher filters.
Lists error codes (F1-F9, FE) with corresponding issues and advice.
Table of common problems like no start, poor washing, or drying issues.
Advice on avoiding damage, checking leaks, and tap location.
Instructions for connecting water inlet and drain hoses.
General| Door color | Not applicable |
|---|---|
| Built-in display | No |
| Appliance placement | Fully built-in |
| Control panel color | Black, Stainless steel |
| Noise level | 52 dB |
| Delay start (max) | 9 h |
| Delayed start timer | Yes |
| Dishwashing programs | Eco, Intensive, Pre-wash, Quick |
| Number of place settings | 10 place settings |
| Number of washing programs | 6 |
| Drying class | A |
| Annual energy consumption | 237 kWh |
| Water consumption per cycle | 13 L |
| Energy consumption per cycle | 0.83 kWh |
Weight and Dimensions| Depth | 570 mm |
|---|---|
| Width | 448 mm |
| Height | 870 mm |
To Next Page
