CDA wc431 User Manual

22
Problem
Possible Cause
The programme will not start
Check the plug, fuse and circuit breakers
of the mains supply
The water tap is turned off
The dishwasher door is not fully closed
The water inlet filter or the machine filters
are blocked
Water remains inside the dishwasher at
the end of the programme
The water drain hose is blocked or kinked
The filters are blocked
The dishwasher stops in the middle of a
programme
Power failure
Water inlet failure
Programme is on standby
Wash performance is of a low standard
Poor loading of dishes hinders wash
performance
Insufficient detergent added
Inappropriate wash programme selected
Spray arm is blocked
Filters clogged or incorrectly fitted
Water drain pump is blocked
White stains on the dishes
Insufficient detergent added
Rinse aid setting is too low
Insufficient dishwasher salt added
Water softener setting is too low
Salt compartment cap may not be
completely closed
The dishes are not completely dry at the
end of a programme
A programme without a drying stage was
selected
Rinse aid setting is too low
Dishes unloaded too soon (allow time for
drying)
There are rust stains on the dishes
Different sets of cutlery should be kept
separate
Too much salt (water softener setting is
too high)
Salt compartment cap not completely
closed
Poor appliance earth (check mains
electrical supply)
The door is not opening or closing
properly
Door tension not correctly adjusted on the
décor door

CDA wc431 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	52 dB
Delay start (max)	9 h
Delayed start timer	Yes
Dishwashing programs	Eco, Intensive, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	6
Drying class	A
Annual energy consumption	237 kWh
Water consumption per cycle	13 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm