9
Starting a programme
• Press the ‘On/O’ button.
• Press the ‘Programme selection’ button until the required
‘Programme’ light is illuminated.
• If required, press the ‘Delay Timer’ button.
• Once a programme is selected, the display will show the desired
programme.
• When you close the dishwasher door the programme will start
automatically.
Please note: The dishwasher stores the most recently used
programme in its memory. To change the programme, simply
press the ‘Programme selection’ button.
At the end of a programme
If possible, do not open the dishwasher door once the programme has
started.
During the programmes cycle the InfoLed will illuminate a red light
underneath the appliance door on to the floor. Once the program has
finished the light illumination will be green.
Changing a programme
It is possible to change the programme if necessary once the
programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press the ‘Programme selection’ button until the required
programme is shown on the display.
• Then close the door. The dishwasher will begin the new programme
from the point at which the old programme stopped.
To Next Page
Loading...
