II. PROGRAMMING
A. RESET MASTER CODE AND DELETE ALL USER CODES
1. Enter the master code twice (12345 default value master code).
2 beeps are emitted to confirm entry in programming mode.
2. Enter *6 to reset the Master Code and the User codes. One beep is emitted. Press
simultaneously on * and # digit keys to reset all memory on the keypad. Wait for two beeps. The
master code is restored to its default value 12345 and all the User codes are deleted from the
keypad. Once the reset is completed then the keypad returns to a stand-by operating mode.
OR
1. Cut the power. Put the jumper on P2.
2. Put the power back. Wait approximately 3 seconds. Two beeps are emitted to confirm reset of
the keypad. Remove P2 jumper. The master code is restored to its default value 12345 and all the
User codes are deleted from the keypad.
B. SETTING CODE LENGTH
1. Enter the master code twice (12345 default value master code). 2 beeps are emitted to
confirm entry in programming mode.
2. Enter *4 to program the code length. One beep is emitted. Enter 4 or 5 for the digit code.
One beep is emitted to confirm programming of the code length.
3. Enter *5 to modify the master code. One beep is emitted. Enter the new 4 or 5-digit master
code. One beep is emitted to confirm programming of the new master code.
Press # to exit from programming mode. 2 beeps are emitted to confirm that the keypad is in
stand-by operating mode.
Master code or user code: 12369
When changing to 4-digit code: Enter 2369
C.
CHANGING THE MASTER CODE
The master code is used only to enter in programming mode
1. Enter the master code twice (12345 default value master code).
2 beeps are emitted to confirm entry in programming mode.
2. Enter *5 to modify the master code. One beep is emitted. Enter the new 4 or 5-digit master.
One beep is emitted to confirm that the master code is programmed.
3. Press # to exit from the programming mode. 2 beeps are emitted to confirm that the keypad
is in stand-by operating mode.
D. ADDING USER CODES
Group 1: from user number 00 to user number 99, relay 1
1. Enter the master code twice (12345 default value master code).
Two beeps are emitted to confirm entry in programming.
• To add user codes:
2. To add a user code, enter the user number (from 00 to 99). If the user number is free 1 beep
is emitted, then enter the 4 or 5-digit user code.
Master code Master code
To Next Page
Loading...
