CDVI PROFIL 100 EC User Manual

Edition 09/2006 G0301FR0270V01
1
M OU N TING KIT
Qty Description
Photo
Funtion
1 M5x8 DIAX
®
screws
Keypad mounting screw
1 DIAX
®
spanner
Spanner
4 M4x30 screws
2 * keypad
2 * remote electronics
4 S5 plastic anchors
2 * keypad
2 * remote electronics
1 05D 680K varistor
For the lock
2 Wiring Sealed caps
Cable to the remote
controller
Keypad: 165 x 43 x 27 MM.
Remote Electronics: 147 x 124 x 55 MM.
OPERATING AND INSTALLATION INSTRUCTIONS
PROFIL 100 EC
Illuminated Mullion Stainless Steel Keypad
Remote Electronics
The PROFIL100EC keypad is available in 1, 2 or 3 relay output.
Refer to page 8 and 9 for the instructions of version 2 and 3 relay.
IP 64 DM

CDVI PROFIL 100 EC Specifications

General

Brand	CDVI
Model	PROFIL 100 EC
Category	Keypad
Language	English

Summary

PRODUCT INFORMATION

DESCRIPTION 1 RELAY OUTPUT VERSION

Details the features and specifications of the 1 relay output version of the keypad.

DEFAULT VALUES

Lists the factory default settings for illumination time, relay release, code length, and master code.

AUDIBLE SIGNAL

Explains the different audible signals generated by the keypad and how to disable them.

CODE LENGTH

Specifies the allowed code lengths (4 or 5 digits) and procedures for code deletion.

REQUEST-TO-EXIT INPUT

Describes the functionality of the request-to-exit input and the timer input for access control.

CONSUMPTION

Outlines the power consumption of the device in standby and active states for different input voltages.

WIRING DIAGRAM PROFIL100EC 1 RELAY OUTPUT

PROGRAMMING

RESET MASTER CODE AND DELETE ALL USER CODES

Instructions for resetting the master code to default and erasing all programmed user codes.

SETTING CODE LENGTH

Guide on how to set the keypad's code length to either 4 or 5 digits.

CHANGING THE MASTER CODE

Procedure for modifying the master code, which is used to enter programming mode.

ADDING USER CODES

Detailed steps for adding new user codes (00-99) for relay 1 activation.

TIME OUTPUTS

Configuration options for keypad illumination time and relay activation (door release) duration.

RESET MASTER CODE

Method to restore the master code to its default value using a jumper on the device.

CHANGING THE CODE BY THE USER

Allows authorized users to modify their own access codes using a jumper setting.

SETTING A SUB MASTER CODE

Procedure for establishing a sub master code to allow users to change their PINs without full programming access.

AUDIBLE SIGNAL

Instructions on enabling or disabling audible feedback during key presses.

PROCEDURE DE MONTAGE DU PROFIL 100 EC

WIRING DIAGRAM PROFIL100 EC 2 and 3 relay outputs

OPTIONAL PROFIL100 EC 2 AND 3 RELAY OUTPUTS

Programming instructions for the KCIN keypad with 2 and 3 relay output versions.

Red and Green LEDs'

Details the wiring and specifications for powering the red and green LEDs on the keypad.