4. Press # to exit from programming mode. 2 beeps are emitted to confirm that the keypad is in
stand-by operating mode.
4 beeps indicate a data computing error.
F. RESET MASTER CODE
On stand-by operating mode, put a jumper on P2. Wait 1 second and then remove the jumper.
One beep is emitted. The master code is restored to its default value 12345 in 5-digit code and
1234 in 4-digit code.
G. CHANGING THE CODE BY THE USER
To authorize a user to modify its own User code put a jumper on P3 (to disable the feature remove
the jumper).
1. Enter the old user code. The relay is activated and a beep is emitted.
2. Enter the 2-digit sub master code (default sub master code A and B).
A beep is emitted to authorize the modification.
3. Enter the new user code. 2 beeps are emitted to confirm the new code.
4. Check the new user code to be sure of the modification.
H. SETTING A SUB MASTER CODE
The Sub Master code allows the user to change its own code without entering in programming
mode. For security reasons the code need to be changed periodically. This feature makes it
easier and faster to change its code.
1. Enter the master code twice (12345 default value master code).
2 beeps are emitted to confirm entry in programming mode.
2. Press *7 to program a sub master code for the user individual Pin code modification. One
beep is emitted. Enter the new 2-digit sub master code. One beep is emitted to confirm
programming of the sub master code.
3. Press # to exit from the programming mode. 2 beeps are emitted to confirm that the keypad
is in stand-by operating mode.
I. AUDIBLE SIGNAL
The audible signal is enabled in programming mode and when the relay is energised after a valid
code.
To enable the audible feedback on a key press:
1. Enter the master code twice (12345 default value master code).
2 beeps are emitted to confirm entry in programming mode.
2. Press * twice. One beep is emitted. Press 0 to disable the audible signal during a keypress.
Press 1 to enable the audible signal during a keypress. One beep confirms the new setting.
4. Press # to exit from programming. 2 beeps are emitted to confirm exit from programming
mode.
P3
*7
To Next Page
Loading...
