cecotec BOLERO SQUAD 2001 - Parts and Components; Before Use; Installation

60
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Cooking zone 1 (1800/2000 W)
2. Cooking zone 2 (1300/1500 W)
3. Hob
4. Power button
5. Control panel
Control panel
Fig. 2
1. Power button
2. Timer button
3. Boost mode button
4. Power/time adjustment buttons
5. Cooking-zone selection buttons
6. Pause
7. Lock
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This product includes a safety package to protect it during transport. Unpack the device
and keep the original packaging and materials in a safe place. It will help prevent any
damage if the product needs to be transported in the future. In case the original packaging
is disposed of, make sure all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the ocial Cecotec Technical Support Service
immediately.
3. INSTALLATION
- Cut out the worktop where the hob is to be tted according to the measurements given in
the table below and Figure 3.
- For installation and use, you must keep a space of at least 5 cm around the recess.
- Make sure the worktop thickness is at least 30 mm. Select a worktop with a heat-resistant