cecotec BOLERO SQUAD V 2001 - Page 49

BOLERO SQUAD V 2001
49
ENGLISH
- The indicators in the cooking zone will show the “-” symbol. The high temperature symbol
will be shown on the cooking zone display if there is residual heat. The time display will
show “--” as well.
- If no cooking zone is activated in standby mode, the appliance will automatically switch o
after 10 seconds and beep.
3. Heating control
- In standby mode, you can choose the cooking zone by pressing the cooking-zone selection
icon. Then, press the / icons to set the power level of the corresponding cooking
zone. Press and hold the / icons to continuously increase or decrease the power
level.
- When the hob is heating, press and hold the power icon for 3 seconds to switch o and
stop heating all cooking zones. The indicator of the corresponding cooking zone that has
been previously heated will show the high temperature warning symbol.
- In standby mode, if any cooking zone still has residual heat, the display will show the high
temperature symbol.
- If you need to switch o one of the cooking zones, you can select that zone rst and then
press the icon to power level “0” to switch o that zone, which will not aect the
heating of the other cooking zone. When the power level reaches “0”, the indicator of the
corresponding cooking zone that has been heated up before will show the high temperature
warning symbol.
- If both zones operate at the same time, the total power will be equal to the sum of the
powers of all cooking zones in operation. Each cooking zone will operate according to its
power modulation ratio and will not aect each other.
Note:
1. During cooking, only one function can be activated or one of the icons on the hob can be
selected, i.e., only one decimal point will be displayed.
2. Press the icon to set the power level to “0”; the hob will automatically switch o.
4. Multi-ring heating function. Fig. 10
4.1. Double cooking ring function: The outer ring can only be switched on once the inner ring
is switched on.
1) Press the cooking-zone selection icon you wish to heat; the decimal point will be shown
on the display of the corresponding cooking zone.
2) Press the / icon to select the desired power level.
3) Press the cooking-zone selection icon again and the corresponding cooking zone display
will show the single ring symbol. Then press the cooking-zone selection icon again to
activate the outer ring. Once activated, the cooking zone display will show the double ring
symbol.
4.2 Triple cooking ring function: The outer ring can only be switched on once the inner ring is
switched on.