ENGLISH
23
3. ASSEMBLY
3
1
2
Main brush and mops installation
1. Install the main brush into the robot’s main
body.
2. Install the main brush’s cover.
3. Adjust the mop to the tank’s bottom part
and press with your hand to make sure it is well
attached.
Water and dust tank installation
4
5
6
7
4. Open the water-filling opening, fill
the tank with water and close it again
following the arrows on the picture.
5. Completely dry the connecting plates.
6. Introduce the dust tank into the
compartment and lower the handle.
7. Introduce the 2-in-1 tank (water and
dust) into the product’s main body.
Conga Serie 1290_Manual_GC.indd 23 25/7/18 7:37
To Next Page
Loading...
