ENGLISH
26
REMOTE CONTROL
ON/OFF/STANDBY/SLEEP
1. ON/OFF
• Make sure the robot’s power switch is ON.
• During standby mode, press on the robot or on the remote control to start the
robot up.
• During sleeping status, press once to switch the robot to standby mode and then
again to start cleaning.
2. Standby
During this status, the robot is switched on and waiting for user operation.
• During operation, press to stop and switch the robot to standby mode.
3. Sleep
During sleep status, press on the robot or on the remote control to start the robot up.
• During standby mode, press on the robot for 5 seconds to enter sleep mode.
• During standby mode, the robot will enter sleep mode after 10 minutes of no
operation.
WATER INTENSITY/TIME SETTINGS
1. Water intensity
• Short press to adjust the water intensity during scrubbing mode. Select
between 1: high, 2: medium, or 3: low. The display will show 1, 2 or 3 and the robot
will emit the number of beeps respectively.
2. Timer settings
• Long press the button to enter the time-settings mode. Use the direction
buttons to select the desired hour and minutes, and then short press to save
the settings.
POWER
• Long press the POWER button for 3 seconds to select the suction power level.
Choose between 1: high, 2: medium or 3: low. The display will show 1, 2 or 3 and the
robot will emit the number of beeps respectively.
TIME AND SCHEDULE SETTINGS
1. Setting time from the remote control
• Press any button from the remote control to turn the display on. The display will
show the remote control’s current time and day.
• Long press the left 2 digits will blink. Use buttons and to increase or
To Next Page
Loading...
