33
ENGLISH
Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened.
Fig. 18.
Attach the mop to the bottom part of the mop bracket with the Velcro.
Fig. 19.
Manually press the tabs on both sides of the mop bracket and push it into its correct position.
You will hear a click when it is properly xed. To remove it, press the Wet & dry tank release
button and pull from the Wet & dry tank.
Fig.20.
Note:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
Add some cleaning agent if considered necessary.
Fig.21.
Warning: Using cleaning agents in excess might block water outlets.
Recommendation: In order to achieve perfect scrubbing, it is suggested to moisten the mop
before using it.
Dust tank installation
Fig.22.
Open the robot cover.
Make sure the dust tank is empty and insert it in its position.
Close the cover again.
5. OPERATION
Once the robot’s light indicator changes from blinking orange to steady blue, the battery
is fully charged and the robot is ready to operate.
The robot cannot operate with low battery.
Remove all cables and obstacles from the oor before operating the robot in order to avoid
accidents and damage.
Robot buttons
Auto mode
From the standby mode, press the power button on the robot, the remote control or on the
App and the robot will automatically start operating. It will carry out a cleaning cycle in zigzag
motion and then another one in Edge mode, Once it has nished, it will return to the charging
base.
It is the most commonly used cleaning mode and it is used to efciently clean the whole house’s
surface. The robot vacuums the oor’s dust automatically, in and organized and efcient way,
To Next Page
Loading...
