cecotec CONGA 3690 - Modes

ENGLISH
31
Modes
The rst time the robot is operated, it will map and memorize the whole house by means of its
laser before starting the cleaning cycle. Use the robot in auto mode and eco power level, this
way you will ensure the robot memorizes the map 100 %.
Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is
activated. If it is not, press any button on the remote control to wake it up.
1. Auto mode
Press on the remote control for it to start cleaning
automatically, rst a cleaning cycle in Edge mode and then
another cycle in and organized zig zag motion, recognizing which
areas it has cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is
cleaning. If during this mode the robot is controlled manually,
the robot will calculate the route again and could go through
previously cleaned areas. In order to ensure efcient cleaning, do not operate it manually
during auto mode cleaning.
Thanks to its TotalClean 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it will
resume the cleaning process from the same point, offering a high-efciency cleaning.
During cleaning, the robot will stop briey to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).
Warning: The robot cleans in an organized way and per squared 4 x 4 m areas, therefore it
might leave the room where it is cleaning to nish off the delimited area. Do not worry about
this, the robot will clean all the accessible surface.
2. Edge mode
Press the on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning
along all the surface’s perimeters and then will return to the
charging base direct and automatically. If the robot has not
started cleaning from the charging base, it will return to the
starting point.