ENGLISH
32
Note: press the POWER button to switch between the 3 modes Turbo/Normal/Eco.
3. Back-home mode
Press the be activated during any other cleaning cycle and the robot will automatically
return to the charging base and stop the cleaning process.
The robot will take the shortest route back to the charging base thanks to its map memorizing
and the smart back-home function.
When a cleaning cycle has been completed or the robot’s battery
is low, thanks to its TotalClean 2.0 technology, the robot will also
return to the charging base to avoid running out of battery. Once
the robot has recharged, it will resume cleaning from the exact
point it has stopped.
Warnings:
• Remove the Wet & dry tank from the robot before charging it.
• Make sure there are no obstacles in the room being cleaned to ensure the robot can get
to the charging base without problems.
Pause
While the robot is operating, press on the App, the remote control or on the robot to pause
it and press to resume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no operation. Press on
the App, the remote control or on the robot to start it up again.
Warning:
• After 12 hours of no operation, the robot will turn automatically off.
• The robot will not enter standby mode during charging.
Suction power level
Press on the remote control to select the desired power level. Choose between Eco (low
power), Medium (medium power) and Turbo (maximum power).
To Next Page
Loading...
