CONGA 3890 | 31
ENGELSK
Press the back home button on the remote control in order to send the
robot to the charging base. This function can be activated during any other
cleaning cycle and the robot will automatically return to the charging base
and stop the cleaning process. The robot will take the shortest route back to
the charging base thanks to its map memorizing and the smart back home
function.
When a cleaning cycle has been completed or the robot’s battery is low,
thanks to its Total Surface 2.0 technology, the robot will also return to the
charging base to avoid running out of battery. Once the robot has recharged,
it will resume cleaning from the point it has stopped.
Notes:
Remove the Wet & dry tank from the robot before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the
robot can get to the charging base without problems.
Pause
While the robot is operating, press the power button on the App, the remote
control or on the robot to pause it and press the same button again to
resume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no
operation.
Press the power button on the App, the remote control or on the robot to
start it up again.
Warnings:
After 12 hours of no operation, the robot will turn automatically o.
The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired
power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high
power).
Schedule
Warning: The robot cannot be scheduled from more than one device at a
time. Make sure to schedule it either from the Smartphone App or from the
remote control.
The robot is provided with a schedule function in order to provide a
To Next Page
Loading...
