cecotec CONGA 3890 - Remote Control Settings; Current Time Setting; Cleaning Scheduling

32 | CONGA 3890
ENGELSK
maximum-eciency cleaning.
The time settings and the cleaning scheduling must be carried out from the
remote control.
Once the robot has been scheduled, it will automatically carry out the
cleaning cycles every scheduled day.
Note: Make sure the robot is activated and that the light indicator is lighted
before scheduling any cleaning or setting time.
Current time
Fig. 17.
Hold down the time button for 3 seconds. The rst 2 digits, indicating the
hour, will start blinking.
Use the up and down direction buttons to set the current time. Then, use
the left and right buttons to switch from hours to minutes and repeat the
before step.
Fig. 18.
Press the time button to save the settings.
Fig. 19.
Cleaning scheduling
Fig. 20.
Long press the schedule button for 3 seconds. The rst 2 digits, indicating
the hour, will start blinking.
Use the up and down direction buttons to set the schedule time. Then, use
the left and right buttons to switch from hours to minutes and repeat the
before step.
Fig. 21.
Press the schedule button again to save the settings.
To cancel the scheduled cleaning, follow the below steps:
Set the clock on the remote control at 00:00 a.m. and save it.
Fig. 22.
Switch the robot o for 1 minute and switch it on again.
Note: The robot will beep to indicate all settings have been saved.
Note: When the remote control’s batteries are replaced, the clock and
schedule times must be set again.
Light indicator:
Operating: Steady blue light.
Low power: Orange light blinks slowly.
Charging: Orange light oscillates.
Network conguration: Blue light blinks slowly.