53
ENGLISH
Install the dust tank back in the robot.
Wet&Dry tank
Take the Wet & dry tank out.
Detach the dust compartment from the rest of the tank.
Open dust compartment and empty it.
Use the cleaning brush to clean the dust compartment.
Assemble the dust compartment in the Wet & dry tank.
Install the Wet & dry tank back in the robot.
If the Scrubbing mode has been used, empty the water tank and then fill it with clean water to
rinse it. Empty it again before installing it back in the robot.
High-efficiency filter
Remove the high-efficiency filter and shake it to remove all the dust.
Recommendations:
Replace the high efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage.
The filter can be washed with lukewarm soapy water. Dry it thoroughly.
Side brush
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its original package.
7. BATTERY REPLACEMENT AND CHARGING
Do not use any other battery, power adapter or charging base than the oneofficiallyprovidedby
Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place. It is suggested to charge the battery every month in order to
avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
To Next Page
Loading...
